恒温恒湿老化房主要用于显示器高温高湿老化，模拟显示器所处最恶劣的环境下试验，保证产品质量，在经过8小时高温高湿老化过程中，产品暴露出应有的缺陷，让不良品在8小时内提前筛选出，提高合格率。越来越多的电子产品行业重视恒温恒湿老化，从单纯的高温老化延伸至恒温恒湿老化，从单一的温度筛选飞跃至温湿度筛选，让以前只有在实验室才会做的温湿度条件放在了车间里，使每一台产品能像在实验室检测出的一样，性能温度，使用寿命长，同时给企业增加了新的机遇，不良品减少，合格率提高，这反应出企业在进步，产品在升级。
Constant temperature and humidity aging room is mainly used for high temperature and humidity aging of display, simulating the test of display in the worst environment to ensure product quality. After 8 hours of high temperature and humidity aging process, the product exposes its defects, so that the defective products can be screened out in advance within 8 hours, so as to improve the qualified rate. More and more electronic products industry attaches importance to constant temperature and humidity aging, from simple high temperature aging to constant temperature and humidity aging, from single temperature screening leap to temperature and humidity screening, so that the temperature and humidity conditions previously only done in the laboratory are placed in the workshop, so that each product can be like the performance temperature detected in the laboratory, long service life, while increasing the number of enterprises. New opportunities have been added, the number of defective products has been reduced and the qualified rate has been raised, which reflects the progress of enterprises and the upgrading of products.
在设计恒温恒湿老化房时，我们应按照实际规格来设计，要了解恒温恒湿老化房的结构（加热、加湿、保温房体、控制模块、恒温恒湿模块），在传统恒温恒湿实验室上进行改进，不需要增加很大的建设成本即可做到恒温恒湿老化。
In the design of constant temperature and humidity aging room, we should design according to the actual specifications. We should understand the structure of constant temperature and humidity aging room (heating, humidification, thermal insulation room, control module, constant temperature and humidity module), and improve the traditional constant temperature and humidity laboratory. We can achieve constant temperature and humidity aging without increasing the construction cost.
在恒温恒湿老化房设计标准上，我们要先考虑产品的产量，去设计房体的结构大小，再去按照GB2423的试验标准要求去做温湿度的条件，把握产品品质。
In the design standard of constant temperature and humidity aging room, we should first consider the output of the product, to design the structure size of the room, and then to do the conditions of temperature and humidity according to the requirements of GB2423 test standard, to grasp the quality of the product.
